User Manual Q&AAnswer
Feb 01, 2025 - 03:27 AM
To connect the LED fixtures to the Rayrun NT10 LED Controller, follow these steps:
1. Locate the LED output terminal on the controller.
2. Install the load positive cable into the terminal marked with a ‘+’ symbol.
3. Install the negative cable into the terminal marked with a ‘-’ symbol.
4. Make sure that the LED rated voltage is the same as the power supply voltage.
5. Ensure that the maximum load current is below the controller's rated current.
It is important to note that if the output is overloaded or short-circuited, the controller will go into protection mode. In this case, the indicator will flash red and the controller will stop working. To resolve this issue, check the wiring and load current to remove the fault.
For more detailed information, please refer to the Rayrun NT10 Smart and Remote Control Single Color LED Controller User Manual.
Add New Comment