User Manual Q&AAnswer
Feb 01, 2025 - 03:14 AM
To install the Asia-Teco K3/K3F/K3Q Smart Access Controller, follow these steps:
1. Drill a hole for the cable: Drill a hole at an appropriate position to make space for the cable to connect to the power source.
2. Install the mounting plate: Remove the mounting plate from the access controller and fix it on the wall using four screws.
3. Wiring: Cut off the connector of the cable, strip and connect the leads to the appropriate ports of the power supply according to the illustration provided.
4. Install the access controller: Fit the access controller into the hook on the mounting plate and fix it with a xxxx at the bottom.
5. Reset to default mode: When the power is on, connect the blue wire (SW) to the purple wire (IN). Then, connect SW and IN to the black wire (GND) for 3 seconds. Disconnect the black wire (GND) when you hear a beep. Repeat this process twice until you hear two short beeps.
6. Pair the access controller with the app: Tap the panel to light it up and activate the lock. Open the app and tap the E icon on the upper left corner. Tap "+Add Lock" and select "Door Lock." Tap the device shown on the screen and wait a few seconds for it to be added successfully.
Please refer to the user manual for more detailed instructions and illustrations.
Add New Comment