User Manual Q&AAnswer
Feb 01, 2025 - 02:34 AM
To set up the MiBOXER LC2-ZR 2 in 1 LED Controller, follow these steps:
1. Set up the output mode: Press the "SET" button continuously to switch the output mode. The output mode sheet will help you confirm the output mode based on the color of the indicator.
2. Linking Code Instructions:
- Power off the controller for 10 seconds and then power it on again, or short press the "SET" button once, or turn on the light via the PUSH switch.
- Short press the "I" button three times within three seconds.
- The lights will blink three times slowly, indicating that the linking is done successfully. If the lights do not blink slowly, please follow the above steps again. Note that lights that have already been linked cannot be linked again.
3. Unlinking Code Instructions:
- Power off the controller for 10 seconds and then power it on again, or short press the "SET" button once, or turn on the light via the PUSH switch.
- Short press the "I" button five times within three seconds.
- The lights will blink ten times quickly, indicating that the unlinking is done successfully. If the lights do not blink quickly, please follow the above steps again. Note that lights that haven't been linked do not need to be unlinked.
4. Auto transmitting (2.4G RF remote signal):
- The light can transmit the remote signal to another light automatically if the distance between lights is 30m. The remote control distance is unlimited. All lights must be linked with the same remote for this to work.
5. PWM high-frequency / low-frequency switching:
- Switch to high frequency (16KHz): Press the "OFF" button once within three seconds and then press the "ON" button five times. The LED light will flash twice quickly to indicate successful activation.
- Switch to low frequency (250Hz): Press the "ON" button once within three seconds and then press the "OFF" button five times. The LED light will flash twice slowly to indicate successful activation.
6. "Do Not Disturb" mode:
- This mode is activated by default. It is useful in areas with frequent power failures to save energy.
- To turn on "Do Not Disturb" mode: Press the "OFF" button three times within three seconds and then press the "ON" button three times. The LED light will flash four times quickly to indicate successful activation.
- To turn off "Do Not Disturb" mode: Press the "ON" button three times within three seconds and then press the "OFF" button three times. The LED light will flash four times slowly to indicate successful deactivation.
Please refer to the instruction manual for more details and information on using the MiBOXER LC2-ZR 2 in 1 LED Controller.
Add New Comment