User Manual Q&AAnswer
Feb 01, 2025 - 01:19 AM
To assemble the JAMARA Push Car Mercedes Benz Antos, please follow the steps below:
1. Tilt prevention: Place the tilt prevention into the rear of the body.
2. Rear axle and rear wheels: Insert the rear wheel axle through the washer, wheel, and bushing into the body. Tighten using a split pin.
3. Front wheels: Assemble the two front wheels by inserting the bushing, wheel, and washer. Tighten using a split pin.
4. Wheel cover: Place the four wheel covers onto the four wheels.
5. Steering column: Slide the steering column from bottom to top through the hole in the body. Insert the bent end of the steering column into the gap at the bottom of the body.
6. Steering wheel: Loosen the bolt and nut in the steering wheel first. Then place the steering wheel over the steering column, insert the bolt, and tighten the nut with a screwdriver.
7. Backrest: Insert the backrest into the designated location at the rear upper end of the car.
8. Signal light: Connect the two wire plugs first, then insert the whole signal light into the car body.
9. Insert the battery: Turn over the car body, open the battery compartment cover, and insert 2 AA batteries. Adhere to the correct polarity and xxxx it tight.
Please refer to the provided instruction manual for visual illustrations and additional information on the assembly process.
Add New Comment