User Manual Q&AAnswer
Feb 01, 2025 - 01:04 AM
To install the , please follow these steps:
1. Ensure the power is turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel. Also, turn off the wall switch before starting the installation.
2. If there is an existing fixture, remove it.
3. Partially xxxx the provided mounting screws into the junction box as shown in figure 1 of the manual.
4. If necessary, strip the supply wires back approximately 1/2".
5. Wrap the white wire (neutral) around one of the silver screws shown in figure 2a. Tighten the silver xxxx to secure the white wire.
6. Wrap the black wire (hot) around one of the brass screws similar to figure 2a. Tighten the brass xxxx to secure the black wire.
7. Ensure there is enough room inside the junction box. Push the supply wires into the junction box and align the xxxx heads with the cutouts in the lamp holder base.
8. Turn the lamp holder until the xxxx head is fully seated in the cutout, then tighten the screws until the lamp holder cannot rotate. Be cautious not to over tighten the mounting screws.
9. The installation is now complete. Install the desired light bulb and restore power.
Note: If the existing cutouts do not line up with the junction box, you may need to open the inner cutout by using a screwdriver to remove the plastic.
For any further questions or concerns, it is recommended to consult an electrician or contact Maxxima directly through their customer support channels.
Please refer to the provided instruction manual for visual references and additional information.
Add New Comment