How do I install the EMERSON RP4AF Bettis RTS Relay Board Electric Actuator? (Emerson RP4AF Bettis RTS Relay Board Electric Actuator Instruction Manual)

Answer

manuals.plus

Jan 31, 2025 - 11:51 PM

To install the EMERSON RP4AF Bettis RTS Relay Board Electric Actuator, follow these steps:

1. Remove all power supplies before starting the installation.
2. Gather the necessary tools: needle nose pliers, Philips screwdriver, flat screwdriver, Allen key 5, and socket wrench 5.
3. Ensure you have the required materials: 1x relay board RP4AF, 2x steel xxxx M3x16, 3x plastic distance 8 mm, 1x plastic xxxx M3x15, 1x plastic nut M3, and 2x lock plates M3 red.
4. Unscrew the 4 hexagon socket screws from the cover and carefully remove it, taking care not to damage the connection cable between the display and logic board.
5. Unscrew the 4 cross recessed screws from the existing logic board and tilt it carefully towards you.
6. Disconnect the cable with the 10-pole connector from the logic board and connect it to the relay board.
7. Insert the plastic xxxx M3x15 into the provided hole and add a plastic distance on it. Then, connect the relay board with the logic board on a suitable connector. Fix the board by adding a plastic nut on the plastic xxxx .
8. Place two plastic distances of 8 mm between the logic and relay board. Insert the M3x16 steel screws through the estimated holes in the logic board, plastic distances, and relay board. Secure the screws with the red lock plates.
9. Reinstall the logic + relay board back into the control, ensuring that any small screws for the original installation are retained. Be careful not to damage any cables or other parts.
10. Connect the cable between the display cover and logic board. It is recommended to perform a firmware update at this stage before installing the display cover. Refer to the separate manual for detailed instructions on how to perform a firmware update.
11. When installing the display cover, pay attention to the O-ring, which must be correctly positioned between the cover and housing. Secure the cover with the 4 hexagon socket screws.
12. The installation is now complete.

Please note that this answer is based on the information provided in the EMERSON RP4AF Bettis RTS Relay Board Electric Actuator Instruction Manual. For more detailed instructions and illustrations, please refer to the manual.