How do I install the EATON FlexiTech Safety Escape AT LED luminaire? (EATON FlexiTech safety LED Instruction Manual)

Answer

manuals.plus

Jan 31, 2025 - 11:46 PM

To install the EATON FlexiTech Safety Escape AT LED luminaire, follow these steps:

1. Disconnect the battery: Before starting the installation, disconnect the battery. Wait for 10 seconds and then reconnect it if you decide to change the configuration.

2. Cable entry: Break through a cable entry using a screwdriver. If the cable entry is on the right, drill in the honeycomb zones (IP43) or in the flexible material (IP65/IP43). Make sure to avoid drilling in the designated zones to prevent any damage.

3. Cabling: Connect the rigid or flexible wire to the connectors of the luminaire. You can use a screwdriver or do it by hand. Refer to the packaging for detailed cabling instructions.

4. Configuration: The luminaire offers different configuration options. You can choose between non-maintained, maintained, and autotest modes. Select the desired mode based on your requirements.

5. LED Indicators: The luminaire has LED indicators that provide information about the status. The LED colors and blinking patterns indicate different conditions. Refer to the manual for a detailed description of the LED indicators.

6. Testing: After installation, you can perform various tests to ensure the functionality of the luminaire. These tests include the magnet test, functional test, and duration test. Follow the instructions in the manual for each test.

7. Battery Replacement: If the battery duration becomes insufficient, you need to replace the battery. Refer to the manual for the specific order code of the battery pack and instructions on how to replace it.

Please note that the above instructions are a general overview of the installation process. For detailed instructions and safety precautions, it is recommended to refer to the EATON FlexiTech Safety Escape AT LED Instruction Manual.