User Manual Q&AAnswer
Jan 31, 2025 - 11:03 PM
To install and set up the NAKAYAMA PRO NP1030 Unclean Water Submersible Pump, please follow these steps:
1. Ensure that all electrical sockets are properly grounded and that no power cord is used for transporting or fixing the equipment.
2. Do not pull or press the power cord on sharp edges.
3. Check that the power supply voltage matches the voltage given on the model board.
4. Only authorized customer service personnel should perform installation and replacement of components.
5. Electrical connections should only be done by electrical professionals and in compliance with state regulations.
6. The pump must be connected with a current type leakage current breaker that carries a rated leakage current of no more than 30 MA.
7. Before running the pump, check the connection of the plug. If the wire is damaged, it must be replaced by the manufacturer, agent, or relevant technical personnel to avoid any danger.
8. Children should not wash or maintain the equipment without supervision.
9. Liquid contamination may occur due to leakage of lubricating oil.
10. The water pump can be connected with a shockproof plug installed according to regulations.
11. Do not use the pump when there is someone in the water.
12. When cleaning and maintaining the pump, always disconnect it from the main power supply.
13. If you encounter any technical issues or have questions, please contact technical staff for assistance.
Please note that this is a general overview of the installation and setup process. For more detailed instructions and safety precautions, please refer to the NAKAYAMA PRO NP1030 Unclean Water Submersible Pump User Manual.
Add New Comment