User Manual Q&AAnswer
Jan 31, 2025 - 10:52 PM
To use the SEALEY TP6806 Adblue Lift Action Pump, please follow these steps:
1. Familiarize yourself with the product application and limitations, as well as the specific potential hazards peculiar to this product. Adhere to health and safety regulations and general workshop practices.
2. Ensure that the pump is in good condition. If any parts are damaged, replace or repair them using genuine parts only. Non-authorized parts will invalidate the warranty.
3. Put on safety eye protection and protective clothing before using the pump.
4. Keep the work area clean, uncluttered, and well-lit.
5. Maintain correct balance and footing while operating the pump.
6. Keep children and unauthorized persons away from the working area.
7. Do not use the pump to extract corrosive fluids.
8. Do not dismantle, tamper with, or adapt the pump for any purpose other than its intended use.
9. Before use, inspect the pump to ensure it has not been dropped or mishandled. Check for any damage.
10. Do not use the pump as a handle to move the fluid drum.
11. To transfer AdBlue or other non-corrosive fluids, connect the pump to a 205L drum using the provided 2" Mauser and 2" BSP adaptor.
12. Attach the 1.36m discharge hose to the pump.
13. Begin pumping by lifting the pump handle and then pushing it down. Each stroke will deliver approximately 250ml of fluid.
14. Ensure that fluids are not discharged in an uncontrolled manner to avoid polluting the environment.
15. After use, clean the pump and store it in a safe, dry, and childproof location.
Please note that this answer is based on the information provided in the SEALEY TP6806 Adblue Lift Action Pump instructions. For more detailed instructions or specific troubleshooting, refer to the instruction manual provided with the product.
Add New Comment