User Manual Q&AAnswer
Jan 31, 2025 - 10:17 PM
To install the HILTI HST3 Stud Anchor Galvanized, please follow the instructions provided in the instruction manual. Here is a step-by-step guide:
1. Determine the appropriate anchor size and length based on your specific application requirements. Refer to the "DIMENSION" section in the manual to find the minimum and maximum values for tfix (anchor length) and hnom (embedment depth).
2. Prepare the base material by drilling a hole with the recommended diameter and depth. The hole diameter should match the anchor size, and the depth should be equal to or slightly greater than the embedment depth (hnom).
3. Clean the hole thoroughly to remove any debris or dust.
4. Insert the anchor into the hole, making sure it is fully seated and flush with the surface.
5. Using a torque wrench, tighten the anchor to the specified torque value. Refer to the "INSTALLATION" section in the manual for the recommended torque values based on the anchor size.
6. Verify that the anchor is properly installed by checking for any visible gaps between the anchor and the base material.
7. Repeat the installation process for each anchor required.
It is important to note that these instructions are a general guideline. For specific installation details and considerations, please refer to the HILTI HST3 Stud Anchor Galvanized Instruction Manual provided with the product.
Add New Comment