User Manual Q&AAnswer
Jan 31, 2025 - 09:05 PM
To add the SILICON LABS ZGM130S Z Wave Module to your Z-Wave network, follow these steps:
1. Put the Z-Wave 700 Module into the lock.
2. Enter the Master Code on the lock keypad.
3. Press 'R', followed by '9', '#', '1', and '#'. This sequence can only be activated in advanced mode.
4. The Z-Wave Module will be added to your Z-Wave network within 10 minutes.
Please note that these instructions assume you have a compatible Z-Wave controller or hub to add the module to your network. Refer to your controller's user manual for specific instructions on adding devices.
For more detailed information, including troubleshooting steps, refer to Section 2.5 "How to factory reset" in the SILICON LABS ZGM130S Z Wave Module User Manual.
Add New Comment