Answer

Jan 31, 2025 - 08:42 PM
To mount the Akuvox C319 Video Intercom Monitor on the wall, follow these steps:
1. Wall-mounting Bracket Installation:
a. Without embedded box in the wall:
- Dig out a square hole in the wall that can accommodate all cables (height*width*depth = 66*50*50 mm).
- Align the square hole of the wall-mounting bracket with the hole in the wall and mark the four fixation holes on the wall.
- Remove the wall-mounting bracket and use a 6 mm hand drill to make the four fixation holes on the wall.
- Insert plastic wall anchors into the holes.
- Twist M3x0.5 hex socket screws into the bottom hole of the wall-mounting bracket until the tail aligns with the edge.
- Fix the wall-mounting bracket on the wall using four ST4x20 crosshead screws. If there is a ground wire, use an M3x6 crosshead xxxx to fix it on the wall-mounting bracket.
b. With embedded box in the wall:
- Ensure all cables are inside the embedded box.
- Twist M3x0.5 hex socket screws into the bottom hole of the wall-mounting bracket until the tail aligns with the edge.
- Fix the wall-mounting bracket on the wall using two M4x30 crosshead screws. If there is a ground wire, use an M3x6 crosshead xxxx to fix it on the wall-mounting bracket.
2. Device Mounting:
- Connect the cables to the device.
- Push down to securely fix the device.
- Tighten the M3x10.5 hex socket xxxx on the device using an Allen wrench.
Please refer to the user manual for more detailed instructions and illustrations on the installation process.
Add New Comment