How do I install the TELLUR TSH02 WiFi Smart Thermostat? (TELLUR TSH02 WiFi Smart Thermostat User Manual)

Answer

manuals.plus

Jan 31, 2025 - 08:18 PM


To install the TELLUR TSH02 WiFi Smart Thermostat, follow the steps below:

1. Central Unit Placement:
   - Choose a suitable location for the central unit, away from heat/cold sources and air outlets.
   - Ensure the power supply is switched off before installation.

2. Central Unit Installation:
   - Insert 2 x AA batteries into the central unit. Make sure to observe the correct polarity.
   - Use a screwdriver to pry open the base and panel frame of the central unit.
   - Place the batteries into the battery compartment and close the back cover.

3. Receiver Installation:
   - Release the front cover of the receiver by inserting a screwdriver into the bottom crack.
   - Choose the wiring method (exposed or concealed) based on your preference.
   - For exposed wiring, open along the dotted line using a flat-blade screwdriver.
   - For concealed installation, open along the dotted line in the middle of the bottom shell.
   - Insert the wire into the terminal and tighten it with a flat-blade screwdriver.
   - After tightening the terminal screws, cover the upper cover to complete the installation.

Please refer to the product manual for detailed diagrams and illustrations of the installation process.

Note: It is important to follow all safety precautions mentioned in the manual, such as switching off the power supply before installation and avoiding wiring damage or abrasion.