User Manual Q&AAnswer
Jan 31, 2025 - 08:16 PM
To set the temperature on the JAMARA 172140 Heat Sealing Iron, please follow these steps:
1. Plug the AC power cord into a proper wall outlet and turn the iron on using the ON/OFF switch.
2. Use the temperature controller to set the desired temperature. The temperature display will show the selected temperature.
3. If the red LED flashes, it indicates that the iron has reached the selected temperature.
4. If you want to switch the temperature display from Celsius to °F, hold down the ON/OFF button for a few seconds after switching on the iron.
5. Adjust and test the temperature by turning the temperature xxxx slowly until the covering material sticks to the balsa wood smoothly.
6. To turn off the iron, press the ON/OFF switch again and unplug it from the wall outlet.
Please note that it is important to refer to the temperature recommended by the foil manufacturer. If the manufacturer has not provided any recommendations, you can use the following guidelines:
- At approximately 100°C, the foil's bonding part will start to glue to the model.
- At approximately 130°C, the foil will stick to the model.
- At approximately 150°C, the foil can shrink.
- At approximately 250°C, the foil will start to melt and become unusable.
It is important to read and follow all safety instructions provided in the manual to ensure safe and proper use of the heat sealing iron.
Add New Comment