User Manual Q&AAnswer
Jan 31, 2025 - 05:43 AM
To measure for a betta Roman blind, follow these instructions:
1. Use a good quality tape measure and measure down to the nearest millimeter.
2. Measure all windows, even if they appear to be the same size.
3. Always indicate the WIDTH measurement first, then the DROP last (e.g., 2100mm x 1800mm).
4. Take all measurements in millimeters.
5. For larger blinds, refer to the Betta Blinds pricing guide sizes to ensure the blind can be manufactured successfully and is covered by any appropriate warranties.
6. Blinds made outside of Betta Blinds recommendations are not covered under warranty.
For Face Fit (Outside Fit) Roman Blind:
1. Measure the width at the top of your opening from architrave to architrave or 50mm - 100mm either side for square set windows.
2. Measure the drop from architrave to architrave or 50mm - 100mm either side for square set windows.
3. When the blind is up, the fabric can hang down in the opening from 250mm - 400mm depending on the drop size.
For Reveal Fit (Inside Fit) Roman Blind:
1. Measure the width from inside of the window to inside the window.
2. Measure the drop from where the blind is being fitted to where you want the blind to finish.
3. When the blind is up, the fabric can hang down in the opening from 250mm - 400mm depending on the drop size.
Please note that these instructions are a guide, and it is recommended to consult with an experienced expert measurer/installer for accurate measurements.
Add New Comment