User Manual Q&AAnswer
Jan 31, 2025 - 05:12 AM
To connect your computer to the RUCKUS R760 Indoor Wi-Fi Access Point, follow these steps:
1. Using an Ethernet cable, connect your computer's network port to the 10G ETH PoE port on the AP.
2. Connect the AC cable of the AC power adapter to a convenient and protected power source. Connect the DC output cable of the AC power adapter to the 48 VDC port on the AP.
Note: Alternatively, you can connect the 10G ETH PoE port to a PoE injector or switch for both power and network connectivity.
Note: The PoE switch port must run the link layer discovery protocol (LLDP) and power over Ethernet/MDI (PoE+) for the AP to operate in full-power mode. Make sure to enable both LLDP and Power through MDI (802.3) on the switch, if available.
Note: If the AP is powered by 802.3at PoE, the supported feature set is reduced. For full functionality, it is recommended to use 802.3bt-compliant PoE to power the AP.
Once the computer is connected to the AP, you can proceed with the setup and configuration process as described in the user guide.
Add New Comment