User Manual Q&AAnswer
Jan 31, 2025 - 03:48 AM
To synchronize the remote sensor with the base station for the ThermoPro TP65 Wireless Humidity and Temperature Monitor, please follow these steps:
1. Position the remote sensor near the base station.
2. Install the batteries in the remote sensor.
3. Once the batteries are installed in the base station, the RF signal icon on the base station display will flash for 3 minutes, indicating that the base station is in synchronization mode.
4. If 3 minutes have passed and the RF signal icon is no longer flashing, press and hold the CHANNEL/SYNC button on the base station for 3-4 seconds until the RF signal icon starts flashing again to set it back in synchronization mode.
5. Wait for a moment or press either the TX or RESET button inside the remote sensor battery compartment.
6. The remote sensor temperature/humidity will show on the base station display, indicating that the synchronization is complete.
Note: Each time the batteries are replaced or the base station/remote sensor loses connection, make sure to follow the synchronization process to pair and re-connect the base station and remote sensor.
If you have additional remote sensors, you can repeat the above steps to register the remote sensors. Up to 3 remote sensors can be registered with one base station.
Add New Comment