How do I connect the DYN-C-3000-LN triaxial capacitive accelerometers to a power supply? (Dynalabs DYN-C-3000-LN Triaxial Capacitive User Manual)

Answer

manuals.plus

Jan 31, 2025 - 01:59 AM


To connect the DYN-C-3000-LN triaxial capacitive accelerometers to a power supply, follow these steps:

1. Identify the cable code/pin configuration:
   - Red: V+ Power supply voltage +5 to +20 VDC
   - Black: Ground Power GND
   - X-Axis: Yellow: Signal(+) Positive, analog output voltage signal for differential mode.
   - Purple: Signal(-) Negative, analog output voltage signal for differential mode.
   - Y-Axis: Blue: Signal(+) Positive, analog output voltage signal for differential mode.
   - Y-Axis: Blue: Signal(+) Positive, analog output voltage signal for differential mode.
   - Z-Axis: White: Signal(+) Positive, analog output voltage signal for differential mode.
   - Orange: Signal(-) Negative, analog output voltage signal for differential mode.

2. Make sure to never connect the power supply and/or the power ground to the colored cables (yellow, purple, blue, green, white, and/or orange). Also, never connect the power supply to the power ground.

3. Connect the power supply voltage (+5 to +20 VDC) to the red cable.

4. Connect the ground power (GND) to the black cable.

5. Connect the analog output voltage signals for differential mode (X-axis, Y-axis, and Z-axis) to their respective colored cables.

6. Ensure that you are using a clean power source within the specified voltage range.

Please refer to the "Operation and Installation" section of the user manual for more detailed instructions and illustrations.