User Manual Q&AAnswer
Jan 31, 2025 - 01:50 AM
To set up and use the EMERSON Go Tracker 1.9 Real-Time Temperature and Location Tracker, follow these steps:
1. Make sure the temperature for the device is within the range of -20˚C to 60˚C. This is the recommended operating temperature for the tracker.
2. Check the frequency bands and maximum radio-frequency power supported by the tracker. The EMERSON Go Tracker 1.9 operates with CAT M1 LTE-FDD, Cat NB2 LTE-FDD, and EGPRS frequency bands. The maximum TX power varies depending on the frequency band.
3. Familiarize yourself with the CE and FCC regulations mentioned in the user manual. These regulations provide important safety and compliance information for using the tracker.
4. Ensure that the device complies with FCC radiation exposure limits. Maintain a minimum distance of 20cm (8 inches) between the device's antenna and any human during normal operation to avoid exceeding the FCC radio frequency exposure limits.
5. If you are in Canada, the device complies with the Innovation, Science and Economic Development Canada license-exempt RSS standard(s). It must not cause interference and must accept any interference that may cause undesired operation.
6. If you have any specific questions or need further assistance with the EMERSON Go Tracker 1.9 Real-Time Temperature and Location Tracker, you can contact the Certification Manager, Mona Delavari, via email at mona.delavari@emerson.com. The address for Emerson Digital Cold Chain, Inc. is 7121 Fairway Dr. #400, Palm Beach Gardens, FL 33418, USA.
Please refer to the user manual for more detailed information and instructions on using the EMERSON Go Tracker 1.9 Real-Time Temperature and Location Tracker.
Add New Comment