User Manual Q&AAnswer
Jan 31, 2025 - 01:01 AM
To change the door hinge on your CLEAVER CSCCO154 Cork Drinks Fridge or Wine Cellar, please follow these steps:
1. Using a thin spatula or butter knife, carefully remove the 5 plastic xxxx hole caps and the cap of the door spindle on the top left-hand corner of the cabinet.
2. Open the door to an angle and unscrew the hinge cover from underneath and remove. Carefully hold the door up, unscrew hinge screws until the upper hinge is loose enough to lift the spindle from the door. Lift the door to remove it from the lower hinge. Remove the hinge screws and upper hinge completely. Place the xxxx caps into the xxxx holes.
3. Remove the screws on the lower hinge and front vent cover.
4. Install the lower hinge on the opposite side and refit the screws into the vent cover.
5. Gently pry the 2 xxxx caps from the door frame. Remove the lower door support. Fix the door support on the opposite side of the door frame.
6. Lift the door gasket/seal to reveal the door handle screws. Remove the screws and handle and fix them onto the opposite side.
7. Loosely fix the upper hinge onto the opposite side of the cabinet.
8. Reposition the nut onto the lower door hinge and slot the door support spindle into the nut.
9. Slot the upper hinge into the door, line up the door, and tighten the hinge screws. Re-fix the hinge cover.
If you have any further questions or encounter any issues during the process, please refer to the user manual or contact the CLEAVER service team at 0418 139 409 for assistance.
Add New Comment