User Manual Q&AAnswer
Jan 30, 2025 - 10:41 PM
To adjust the wastegate on your EVOLUTION POWERSPORTS 004FC0083 CAN AM Maverick X3 195 HP Turbo RR ECU Power Flash, follow these steps:
1. Remove the panel between the seats that allows access to the turbocharger.
2. Using a small flat blade screwdriver, remove the retaining clip that holds the wastegate actuator rod onto the wastegate arm. Be careful not to lose the retaining clip.
3. Using a 10mm wrench, loosen the jamb nut on the wastegate rod. If the jamb nut is too tight, you may have to remove the wastegate actuator from the turbo.
4. xxxx the rod end clockwise to shorten the arm and raise the crack pressure. Conversely, lengthen the rod to lower the crack pressure. Check the crack pressure with a Mityvac. You can refer to the YouTube video provided by EVOLUTION POWERSPORTS for the correct way to do this.
5. Check the pressure three times to ensure it is correct.
6. Put the wastegate rod end back onto the wastegate arm.
7. Reinstall the retaining clip and tighten the jamb nut.
Please note that adjusting the wastegate should be done carefully and accurately to ensure optimal performance. If you are unsure or uncomfortable with performing this adjustment, it is recommended to seek assistance from a professional or contact EVOLUTION POWERSPORTS for further guidance.
Add New Comment