User Manual Q&AAnswer
Jan 30, 2025 - 10:14 PM
To select the desired routing pattern on the ADDAC809 Chain Router, you need to use the CV input labeled "PATTERN." This CV input allows you to dynamically control the routing pattern based on the incoming control voltage.
The ADDAC809 Chain Router offers six different routing patterns, as mentioned in the product description. By applying different control voltages to the "PATTERN" input, you can switch between these patterns. Here is a breakdown of the routing patterns and the corresponding control voltage ranges:
1. IN > OUT: Apply a control voltage below 1V to select this pattern.
2. IN > CHAIN A > OUT: Apply a control voltage between 1V and 2V to select this pattern.
3. IN > CHAIN B > OUT: Apply a control voltage between 2V and 3V to select this pattern.
4. IN > CHAIN A > CHAIN B > OUT: Apply a control voltage between 3V and 4V to select this pattern.
5. IN > CHAIN B > CHAIN A > OUT: Apply a control voltage between 4V and 5V to select this pattern.
6. IN > > OUT: Apply a control voltage above 5V to select this pattern.
By modulating the control voltage, you can dynamically switch between different routing patterns in real-time. This feature allows for flexible and creative signal routing possibilities within your modular setup.
For further assistance or if you encounter any issues, you can contact ADDAC System directly at addac@addacsystem.com. They will be able to provide you with additional support and address any feedback, comments, or problems you may have.
Add New Comment