User Manual Q&AAnswer
Jan 30, 2025 - 09:26 PM
To connect the myTEM SmartHome MTDIM-100 Dimmer Module to your smart home system, please follow these steps:
1. Make sure that the device is disconnected from the power supply or that the devices in the control cabinet are disconnected from the mains.
2. Connect the device according to the circuit diagram provided in the myTEM ProgTool or the terminal assignment from the manual. Incorrect wiring can result in injury, death, or damage to the device.
3. Ensure that the device is only operated with stabilized power supplies of 24 VDC. Connecting it to higher voltages will damage the device.
4. If this is the last device on the CAN bus, connect the terminating resistor of 120 Ω enclosed with the myTEM Smart Server via terminals (CAN +/-).
5. Switch on the power supply and, if necessary, check the wiring with the manual positions via the DIP switch. Take care of your safety as the devices are live.
For more detailed information and illustrations, please refer to the "Installation" section of the instruction manual for the myTEM SmartHome MTDIM-100 Dimmer Module.
Add New Comment