User Manual Q&AAnswer
Jan 30, 2025 - 09:23 PM
To pair the Satellite Electronic 18033 Ceiling Fan Remote Controller with your ceiling fan, follow these steps:
1. Install two AAA 1.5V batteries in the transmitter.
2. Within 30 seconds of turning on the AC power to the receiver, press the LEARN button on the transmitter.
3. Hold the LEARN button for about 3 seconds. Once the receiver detects the ID, the ceiling fan's light will blink twice and the fan will turn on at low speed. This indicates that the receiver has learned the ID from the transmitter.
- Note: If the 0/1 switch on the back of the transmitter is in the "0" state, the ceiling fan can be directly controlled without pairing. If the switch is in the "1" state, the learning process is required.
4. After completing the steps above, you should be able to operate the ceiling fan and light using the remote control. If the ceiling fan is not responding to the transmitter, turn off the power to the receiver and repeat steps 1 and 2.
Please make sure not to press any other buttons on the transmitter before the learning process is complete, as it may cause the procedure to fail. Additionally, if the remote control will not be used for a long period of time, it is recommended to remove the batteries to prevent damage. When disposing of the transmitter, remember to remove the batteries and dispose of them safely.
For further assistance or troubleshooting, consult the user manual or contact the dealer or an experienced technician.
Add New Comment