User Manual Q&AAnswer
Jan 30, 2025 - 08:29 PM
To connect the Trust 24635 Bayo Mouse Ergonomic to your computer, please follow the steps below:
1. Make sure your computer is turned on and running.
2. Locate an available USB port on your computer.
3. Take the USB receiver that came with the mouse and insert it into the USB port. The USB receiver is a small device that looks like a USB flash drive.
4. Once the USB receiver is inserted, your computer should automatically detect the mouse and install any necessary drivers. This process may take a few moments.
5. After the drivers are installed, the mouse should be ready to use. You can now move the mouse around and it should be responsive on your computer screen.
If the mouse is still not working after following these steps, please try the following troubleshooting tips:
1. Make sure the batteries in the mouse are properly inserted and have sufficient power. If the batteries are low, replace them with fresh ones.
2. Try using a different USB port on your computer. Sometimes, certain USB ports may not provide enough power for the mouse to function properly.
3. Restart your computer and try connecting the mouse again.
4. If none of the above steps work, please consult the user manual that came with the mouse or visit the Trust website at www.trust.com/24731/faq for further assistance.
Please note that the above instructions are based on the general setup process for the Trust 24635 Bayo Mouse Ergonomic. For specific instructions or troubleshooting tips, it is recommended to refer to the user manual or contact Trust customer support for further assistance.
Add New Comment