User Manual Q&AAnswer
Jan 30, 2025 - 05:47 AM
To turn on the GNB LAB Alle Lux 5 Lamp, follow these steps:
1. Connect the lamp to the power supply using the provided power cable.
2. Press and hold the ON/OFF button for 1-2 seconds. The display will show a countdown.
3. If you want to enter standby mode instead of starting the timer, press the ON/OFF button again.
4. Choose the desired timer option by pressing the corresponding time switch button. You can select from 10 seconds, 30 seconds, 60 seconds, or 99 seconds.
5. If you select the 99 seconds mode, the heating power will gradually increase to reduce the risk of nail plate burning caused by gel curing.
6. Alternatively, you can start the lamp without choosing a specific time by placing your hand inside the device. The sensor will detect movement and automatically start the heating process. The maximum operating time in this mode is 120 seconds.
Please note the following warnings and precautions:
- Use the correct voltage for the lamp (100/240V 50/60Hz 1A).
- Keep the lamp away from water and other fluids.
- Do not use the lamp in damp rooms or if the power supply is damaged.
- Do not use the lamp if the device or connection cable is damaged.
- If the timer buttons are not working, do not use the lamp.
- Do not leave the lamp in operation for more than 60 minutes to avoid reducing its lifetime.
- If the device temperature becomes too high, the display will show "07p". Wait until the message disappears before resuming operation.
- If you experience any sudden changes on your skin, consult a doctor immediately.
- The lamp is designed for indoor use only.
- Keep the lamp out of the reach of children.
For any warranty-related issues or repairs, please refer to the warranty card provided with the device.
Add New Comment