User Manual Q&AAnswer
Jan 30, 2025 - 05:38 AM
To assemble the Interiors 1900 CMP86AB Table Light, please follow these steps:
1. Ensure that the product is disconnected from the mains power supply before starting the assembly process.
2. Place the lamp base on a stable and flat surface.
3. If provided, attach the lampshade to the lamp base according to the specific instructions for your model. Note that the lampshade and bulb may need to be ordered separately.
4. Once the lampshade is securely attached, you can proceed to install the bulb. Make sure to use a bulb with the wattage specified on the label to avoid damaging the fitting.
5. After the bulb is installed, plug the lamp into a 220-240V~ 50Hz power supply.
6. Finally, operate the switch to turn on the lamp and check if the bulb lights up. If the bulb does not light up, please refer to the troubleshooting section in the manual for further guidance.
Please note that if you are unsure about any aspect of the installation or use of this product, it is recommended to consult a qualified electrician for assistance.
Add New Comment