How do I install the KONICA MINOLTA Reflection 2 Mini D5 PWM D-RGB Mini Distro Plate Strix in my PC case? (KONICA Mini D5 PWM D-RGB Plate Strix User Guide)

Answer

manuals.plus

Jan 30, 2025 - 05:23 AM

To install the KONICA MINOLTA Reflection 2 Mini D5 PWM D-RGB Mini Distro Plate Strix in your PC case, follow these steps:

1. Before installing the distribution plate, carefully read the PC case manual.
2. Unscrew the factory-provided screws and remove the top panel from the case.
3. Remove the side and front panels from the case.
4. Carefully place the EK-Quantum Reflection2 PC-O11D Mini D5 PWM D-RGB distribution plate into the PC case and align the mounting holes.
5. Secure the distribution plate to the chassis with eight (8) M4 x 8 DIN7991 screws.
6. Use the recommended distribution plate configurations provided in the manual. It is mandatory to use at least one of each type of port and seal all remaining ports using the supplied plugs.
7. Connect the D-RGB LED strip by plugging the 3-pin connector of the distribution plate D-RGB LED light to the D-RGB HEADER on the motherboard.
8. Connect the pump by using the SATA connector to power the pump and the 4-pin PWM fan connector to control and report the rotational speed of the pump. Connect it to your motherboard's CPU_Fan or designated water pump header.
9. After installation, it is recommended to perform a leak test for 24 hours to ensure there are no coolant leaks. Connect the pump to a PSU outside of your system, turn on the PSU, and let the pump run continuously. Inspect all parts of the loop and fix any leaks if found.
10. Ensure all hardware is dry before powering on the system to prevent any damage.

For further assistance, spare parts, or ordering a new mounting mechanism, you can contact the customer support of KONICA MINOLTA at https://www.ekwb.com/customer-support/.