User Manual Q&AAnswer
Jan 30, 2025 - 04:37 AM
To connect the FLASH PROFESSIONAL P7110029 Square 250 IP LED PAR to the power supply, you will need to use a power cable with a powerCON connector. The powerCON socket is located on the device. Simply plug one end of the power cable into the powerCON socket on the device and the other end into a power outlet.
To connect the DMX signal, you will need a cable with XLR-female to XLR-Male plugs. The device is equipped with a DMX IN and DMX OUT interface, both using XLR 3-pin sockets. Connect the DMX signal by plugging one end of the cable into the DMX OUT socket of your DMX controller or the previous device in the DMX chain, and the other end into the DMX IN socket of the FLASH PROFESSIONAL P7110029 Square 250 IP LED PAR.
Please note that all connections, including the power supply and DMX signal, should be performed by qualified personnel to ensure proper installation and safety.
Add New Comment