How do I install the markem-imaje X30 SmartDate Thermal Transfer Printer? (markem-imaje X30 SmartDate Transfer Printer Instruction Manual)

Answer

manuals.plus

Jan 30, 2025 - 03:46 AM

To install the markem-imaje X30 SmartDate Thermal Transfer Printer, follow these steps:

1. Ensure that you have the necessary services and control signals available, including power (100-230V AC, 50-60 Hz), a protective earthing conductor, and a 'Print Go' signal.

2. Make sure there is sufficient space for installation and operation.

3. If you are not a qualified Markem-Imaje service technician or approved distributor, consult the applicable local regulations and seek advice from your Markem-Imaje representative before proceeding with the installation.

4. Connect the printer to the power source using the supplied power cord. Ensure that a disconnect device is located close to the SmartDate Controller and easily accessible at all times.

5. Connect the protective earthing conductor to the installation protective earthing conductor.

6. Connect the 'Print Go' signal, which can be either a volt-free contact or a 24 V DC signal from a PNP sensor.

7. If using the SmartDate X30 continuous printer, connect an encoder to monitor the substrate speed.

8. Once the printer is properly connected, ensure that all covers are in place using the appropriate number of fasteners.

9. If the printer is integrated into a machine, refer to the user manual for the machine before working on the printer.

10. Only after the end machine in which the printer is incorporated has been declared to comply with relevant provisions should the printer be commissioned for operation.

Please note that these instructions are a summary and it is important to refer to the markem-imaje X30 SmartDate Thermal Transfer Printer Instruction Manual for detailed installation procedures and safety precautions.