How do I install the Kimex 031-1028 LED Adapter Plate 30x10mm? (Kimex 031-1028 LED Adapter Plate 30x10mm Installation Guide)

Answer

manuals.plus

Jan 30, 2025 - 03:24 AM


Installation of the Kimex 031-1028 LED Adapter Plate 30x10mm is a straightforward process. Please follow the steps below:

1. Ensure that the power source is turned off before starting the installation process.

2. Take the LED adapter plate and align it with the desired location on the surface where you want to install it. Make sure the surface is clean and free from any dust or debris.

3. Once you have determined the correct position, mark the mounting holes on the surface using a pencil or marker.

4. Drill pilot holes at the marked positions using an appropriate drill bit. The size of the drill bit should be slightly smaller than the screws provided with the adapter plate.

5. Insert the screws through the mounting holes on the adapter plate and align them with the pilot holes on the surface.

6. Using a screwdriver, tighten the screws until the adapter plate is securely fastened to the surface.

7. Connect the LED lights to the adapter plate according to the manufacturer's instructions. Ensure that the connections are secure and properly insulated.

8. Once the LED lights are connected, turn on the power source and test the functionality of the lights.

Please note that this installation guide provides general instructions. It is always recommended to refer to the specific manual provided by the manufacturer for detailed installation steps and safety precautions.