How do I install the ELATEC RFID System TWN4 LEPTO M into a host device? (ELATEC RFID System TWN4 LEPTO M User Manual)

Answer

manuals.plus

Jan 30, 2025 - 02:46 AM


To install the ELATEC RFID System TWN4 LEPTO M into a host device, follow these steps:



1. Ensure that you are a trained and qualified personnel for installing electronic components.

2. Follow general ESD protective measures during the installation, such as using an antistatic wristband or special gloves.

3. Do not touch the antennas, printed circuit boards, connectors, or other sensitive components on the TWN4 LEPTO M.

4. Be aware that metallic materials in or near the product might reduce its reading performance.

5. Before installing the TWN4 LEPTO M into a host device, read and understand the ELATEC technical documentation related to the TWN4 LEPTO M and the host device.

6. Make sure to read and follow the instructions and safety information given in the user manual of the TWN4 LEPTO M and include them in the technical documentation of the host device.

7. Install the reader module in a corresponding recess in the housing of the host device.

8. Connect the reader module to the host device using a USB connection.

9. Ensure that the operational conditions stated in the user manual and other technical documents are met.

10. Verify that the host device complies with all applicable regulations after integrating the TWN4 LEPTO M.



Please note that this is a general overview of the installation process. For more detailed instructions and specific requirements, refer to the ELATEC RFID System TWN4 LEPTO M User Manual.