User Manual Q&AAnswer
Jan 30, 2025 - 12:20 AM
To assemble the Ventair WAL45 Wall Mounted Fan, follow these steps:
1. Assembling the Blade and Grill:
a. Unscrew the 4 x Rear Grill Locking Screws from the Motor Housing.
b. Align the Rear Grill on the Motor Housing and fix it in place using the 4 x Rear Grill Locking Screws.
c. Remove the plastic sleeve on the Motor Shaft and unscrew the Blade xxxx .
d. Slide the Fan Blade onto the Motor Shaft as far as it will go. Replace the Blade xxxx into the slot on the Motor Shaft and tighten clockwise.
e. Loosen the Grill Locking xxxx on the bottom of the Grill Ring (do not loosen fully). Press the Grill Ring over the Rear Grill so that the Rear Grill fits into the groove on the Grill Ring.
f. Position the Front Grill in front of the Rear Grill. Push each section of the Front Grill onto the groove so that the Grill Ring fits around both grills.
g. Tighten the Grill Locking xxxx (and Nut) on the bottom of the Grill Ring. Press the Grill Ring Cover onto the Grill Ring so that the Grill Locking xxxx fits into the groove.
2. Assembling the Fan Body:
a. For the Wall Fan model, use the 2 x Expansion Bolts, 2 x Ceiling Anchors, and 2 x Ceiling Screws to fix the fan in place.
b. For the Pedestal Fan model, place the Tube on the Base; insert and tighten the 4 x Base Screws through the corresponding holes and Base weight. Put on the Base Spring Washer and Base Flat on the Base xxxx , and then secure the 4 x Base Screws with 4 x Base Wing Nut.
c. For the Pedestal Fan model, loosen and remove the Height Adjustment Collar from the top of the Outer Tube. Slide the Base Decorative Cover down over the Outer Tube. Pull the Inner Tube out to the desired height, and then re-attach the Height Adjustment Collar.
d. For the Pedestal Fan model, slide the Motor Housing onto the Inner Tube (if necessary, loosen the Neck xxxx first). Reinsert and tighten the 2 x Neck Screws.
Please refer to the Ventair WAL45 Wall Mounted Fan Instruction Manual for detailed diagrams and instructions.
Add New Comment