User Manual Q&AAnswer
Jan 29, 2025 - 11:13 PM
To install the 23ZERO Panther 2000 Aluminium Hardshell Roof Top Tent on your vehicle, please follow the instructions provided in the user manual. Here is a step-by-step guide:
1. Before installing the tent, make sure you are aware of your vehicle's maximum roof load rating and your roof rack's maximum load rating, including off-road capacity. Ensure that your vehicle and roof rack can safely accommodate the weight of the tent.
2. The tent must be fitted to roof racks with hinges facing the left-hand side of the vehicle (AUS passenger side). It will open over the right-hand side (AUS driver's side).
3. Clamp the four corners of the tent using the 8 x 45mm M8 Bolts with slides and the four mounting plates supplied. Lift the roof top tent on top of the vehicle's roof rack (minimum 4-person lift).
4. Slide four 45mm M8 Bolts with slides into each bottom mounting rail. Position these so that there are two bolts toward the front of the tent and two bolts toward the rear of the tent on each rail. Lift or tilt the roof top tent to allow the inner bolts to cross over onto the inside of the roof bars.
5. Inspect the position of the roof top tent to ensure it will open in the desired position. Place a mounting plate under the roof bar while locating the bolts and hand tighten the Nylok nut. Repeat for all four corners. Double-check the tent's position and tighten all nuts securely with a 13mm spanner. Insert end caps into the ends of the mounting rails.
6. After installation, regularly check that all nuts and bolts attaching the roof top tent to the vehicle, as well as hinges and locks, are tight and in good repair.
Please note that this is a general overview of the installation process. For more detailed instructions and diagrams, please refer to the user manual provided with the product.
Add New Comment