User Manual Q&AAnswer
Jan 29, 2025 - 09:52 PM
To configure the GRS Push and Pull Spinner V2, you will need to follow these steps:
1. Download the GRS Spinner Configuration Tool from the provided link (only applicable for TS-DOT-02 and TS-BSP-02 versions or above).
2. Connect the USB cable JST side to the spinner P2.
3. Make sure the button output mode is "Enabled" for the spinner.
4. Connect the USB wiring harness JST side with the conversion board.
5. Connect the larger JST side of the wiring harness for push buttons with the other side of the conversion board.
6. Hook up the wiring harness for push button IO larger JST connector with P2 on the spinner.
7. Hook up the smaller connector from the wiring harness for push button with P1 on the spinner.
8. Connect the two JST 2.54 connectors for the push and pull buttons with your external encoder board.
9. Finally, connect the USB cable to your device.
Once these steps are completed, your GRS Push and Pull Spinner V2 should be configured and ready to use with your device. For further customization options, you can use the GRS Spinner Configuration Tool to adjust spinner cursor movement, resolution, append an ID to the driver's name, and calibrate the "Push" and "Pull" buttons.
Add New Comment