User Manual Q&AAnswer
Jan 29, 2025 - 09:12 PM
To fill the Power Prep sink with water, follow these steps:
1. Make sure the power to the unit is turned off before starting.
2. Locate the water level probe at the rear wall of the wash tank. It is a white plastic disc with a metal center.
3. Fill the sink with water until the water level is approximately 1 inch above the water level probe. Do not fill it closer than 4 inches below the top of the sink.
4. Press and hold the green button to start the pump.
5. Once the pump is running, the water will become turbulent, and a strong back-to-front current will be established.
6. You can now begin placing your product in the Power Prep sink for deglazing or washing.
Please note that it is important to adjust the knobs on the spray rinse and water faucets to ensure that the water temperature is below 120°F (49°C) to prevent scalding. Also, do not place knives or other sharp objects in the Power Prep sink as it may cause damage to the equipment and pose a risk of injury.
Add New Comment