User Manual Q&AAnswer
Jan 29, 2025 - 09:02 PM
To set the system time on the HAPPY HENHOUSE Automatic Chicken Coop Door Opener Kit, follow these steps:
1. Make sure the end of the rope is tied to the door and is tight to prevent any issues with the internal rope.
2. Press any key to light up the screen.
3. Press the "O" button to enter the settings.
4. The hour will start flashing. Use the "-" and "+" buttons to set the desired hour. Press "O" to save and move to the minute setting.
5. The minute will start flashing. Use the "-" and "+" buttons to set the desired minute. Press "O" to save.
6. The next step is the opening height calibration, but it is important to complete both Step 01 and Step 02. If skipped, the previous setting will be maintained.
7. The "Iii" icon will be displayed, and the opening GIF will be shown on the right side of the screen. Use the "-" and "+" buttons to adjust the door height until it is fully open.
8. Press "O" to save and move to the closing height calibration.
9. The "Iii" icon will be displayed, and the closing GIF will be shown on the right side of the screen. Use the "-" and "+" buttons to adjust the door height until it is fully closed.
10. Press "O" to save and move to the opening mode setting.
11. The "6" icon will be displayed, indicating the coop door is fully open. Use the "-" and "+" buttons to switch between the various modes. The top icons will change to indicate the selected mode.
12. Press "O" to select the required mode and enter its settings.
13. The closing mode setting will be displayed next. Follow the same steps as in the opening mode setting to select the desired mode.
14. After completing the closing mode setting, the screen will display "SAVE," indicating the end of the setup process. The screen will power down in 120 seconds to save battery.
Note: During the setup process, the battery level icon will not be displayed. You can judge the progress by looking at this icon. The main interface will display the system time and the selected mode.
Add New Comment