User Manual Q&AAnswer
Jan 29, 2025 - 05:48 AM
To adjust the detection range diameter of the Hager EE883 Hyper Frequency Motion Detector, please follow the steps below:
1. Locate the motion detector on the wall or ceiling where you have installed it.
2. Use a screwdriver to remove the cover of the motion detector, exposing the adjustment controls.
3. Look for the detection range adjustment control. It is usually labeled as "Range" or "Sensitivity."
4. Using a small screwdriver or a similar tool, rotate the detection range adjustment control clockwise to increase the range or counterclockwise to decrease the range.
5. Test the motion detector by walking within the desired detection range to ensure it is adjusted to your preference.
6. Once you are satisfied with the detection range, securely fasten the cover back onto the motion detector.
Please note that the specific location and labeling of the detection range adjustment control may vary slightly depending on the model and version of the Hager EE883 Hyper Frequency Motion Detector. Refer to the owner's manual for detailed instructions and illustrations specific to your device
Add New Comment