How do I install the EVOLUTION POWERSPORTS 203FC0051 X3 The Clamp Plenum Brace? (Evolution Powersports 203FC0051 Plenum Brace Instruction Manual)

Answer

manuals.plus

Jan 29, 2025 - 04:25 AM


Here are the installation steps for the EVOLUTION POWERSPORTS 203FC0051 X3 The Clamp Plenum Brace:

Step 1: Remove the rear valence.
Step 2: Remove the muffler.
Step 3: Unplug the MAP sensor and remove it from the plenum.
Step 4: Cover the MAP sensor hole with tape.
Step 5: Use a Dremel tool or air grinder to carefully remove the tabs shown in the picture. Only remove as much material as necessary for the installation of THE CLAMP, ensuring the integrity of the runners is not compromised.
Step 6: Install the left half of the inside first, followed by the right half.
Step 7: Install all three pieces and start all four bolts before tightening them down. Apply Loctite to the threads of the bolts.
Step 8: For the two bottom bolts, it is easiest to use a 6mm Allen socket for tightening.
Step 9: Tighten all four bolts.

If you require further assistance, please call Evolution Powersports Tech Support at (715) 247-3862.

Note: This product is exempt from emission standards and related requirements. It is intended for use only in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing, and not for recreational purposes or on public highways. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. By purchasing this product, you represent and warrant that it is being used in compliance with applicable state and/or federal laws.