How do I install the SHADA 2400112 LEDs Light Basic T8 luminaire with LED tube? (Shada 2400112 LEDs Light Basic Instruction Manual)

Answer

manuals.plus

Jan 29, 2025 - 02:56 AM

To install the SHADA 2400112 LEDs Light Basic T8 luminaire with LED tube, please follow the instructions below:

1. Ensure that you have fully read and understood the instructions in the manual before starting the installation.
2. Before installing, disconnect the product from the power source.
3. Check the product and its components for any damage or defects. If any part is damaged or defective, replace it immediately.
4. Make sure the product is sufficiently ventilated during use. Do not cover the electrical (LED) device during usage, as it can generate heat and cause damage.
5. Determine the appropriate location for installation. Ensure that the product is meant for indoor and/or outdoor use, as specified on the product/parts or in the manual.
6. Follow the provided installation/wire diagram (if applicable) to properly connect the product.
7. If a non-standard consumer (power) installation is required, it is recommended to have a qualified technician perform the installation to reduce the risk of electric shock.
8. Once the installation is complete, reconnect the product to the power source.
9. Keep the product out of reach of children or animals.
10. If you have any further questions or encounter any problems during installation, disconnect the product from the power source and refer to the manual for troubleshooting steps or contact customer support.

Please note that the above instructions are a general guideline. For specific details and diagrams, refer to the SHADA 2400112 LEDs Light Basic Instruction Manual provided with the product.