User Manual Q&AAnswer
Jan 29, 2025 - 12:47 AM
To connect the ZPE-RL4-U01 4 Channel Relay Module to your Nodegrid Serial Console, follow these steps:
1. Locate an available USB 2.0 or USB 3.0 port on your Nodegrid Serial Console or a USB hub connected to Nodegrid hardware.
2. Connect the module to the USB port using the provided USB Mini B to USB Type A cable. The cable is detached and has a length of 3 meters (10 feet).
3. Once connected, you can mount the module on a suitable surface using screws or mounting tape. Ensure that the surface allows for the passage of wires.
4. Before proceeding, make sure that your Nodegrid OS version meets the minimum requirements for the module. If not, upgrade your Nodegrid OS to at least version 5.4.1.
5. For more detailed installation instructions, you can refer to the "Sensor Quick Install Guide" section in the user manual available at https://www.zpesystems.com/user-manua...
By following these steps, you will be able to successfully connect the ZPE-RL4-U01 4 Channel Relay Module to your Nodegrid Serial Console.
Add New Comment