User Manual Q&AAnswer
Jan 28, 2025 - 11:56 PM
To program the Scorpion Automotive S37 S Series alarm system to arm and disarm via the turn indicators, follow these steps:
1. Disconnect the 8-way wiring connector from the 8-way alarm connector.
2. Turn the ignition key to the "ON" position.
3. Connect the 8-way wiring connector to the 8-way alarm connector. The LED on the alarm system will turn on steadily.
4. Turn the ignition key to the "OFF" position.
5. Close all doors and press the lock button on the original remote control or the optional Gemini remote.
6. When the turn indicators stop flashing, the LED on the alarm system will turn off for 1 second.
7. Press the unlock button on the original remote control or the optional Gemini remote.
8. When the turn indicators stop flashing, the LED on the alarm system will turn off.
9. This completes the programming procedure.
Note: If you want to cancel the programming of the turn indicators, you can reset the system by following the instructions in chapter 13.0 of the manual.
Please refer to the Scorpion Automotive S37 S Series Installation Guide for more detailed instructions and illustrations.
Add New Comment