User Manual Q&AAnswer
Jan 28, 2025 - 11:50 PM
To connect the DYN-IS-10 Inertial Shaker to an external signal source, follow these steps:
1. Make sure the Gain xxxx on the amplifier is turned counterclockwise to the lowest gain position.
2. Connect the DC power source and the drive signal to the shaker power input and signal input, respectively.
3. Start the external signal source.
4. Adjust the Gain of the amplifier by turning the Gain xxxx clockwise.
By following these steps, you will be able to connect the DYN-IS-10 Inertial Shaker to an external signal source and adjust the gain for your desired operation. For more detailed instructions, please refer to the "Operation and Installation" section of the instruction manual.
Add New Comment