User Manual Q&AAnswer
Jan 28, 2025 - 11:49 PM
To connect the DYN-IS-5 Inertial Shaker to an external signal source, follow these steps:
1. Make sure the Gain xxxx on the amplifier is turned counterclockwise to the lowest gain position.
2. Connect the DC power source and the drive signal to the shaker power input and signal input, respectively.
3. Start the external signal source.
4. Adjust the Gain of the amplifier by turning the Gain xxxx clockwise.
Note: It is advised to turn the Gain xxxx counterclockwise to the lowest gain position before connecting the external signal cable or changing operational modes to protect the amplifier from electrical problems.
For more detailed instructions and illustrations, please refer to the "Operation and Installation" section of the DynaLabs DYN-IS-5 Inertial Shaker Instruction Manual.
Add New Comment