User Manual Q&AAnswer
Jan 28, 2025 - 11:19 PM
To adjust the pressure and flow compensator on the Danfoss M Series Piston Pump, please follow the steps outlined in the instruction manual provided. Here is a general overview of the process:
1. Ensure that a relief valve is fitted between the pump and the load to protect against overload of the pump or system.
2. NEVER adjust the compensator to allow the pump or the hydraulic system to exceed their maximum rated pressures. Refer to the operator's manual for maximum pressures or contact the supplier.
3. Excessive pressure may result in abrupt and serious failures in the system, which can cause death or serious bodily injury to nearby persons and/or damage the pump.
4. The pressure and flow compensator kit includes the compensator itself, cap screws, and O-rings.
5. Refer to the parts information and service data documents provided for specific details on the compensator and its installation.
6. If you require further assistance or have specific questions about adjusting the pressure and flow compensator, it is recommended to contact Danfoss or their authorized service center for expert support. Please note that the information provided here is a general overview and it is important to refer to the specific instructions and guidelines provided in the instruction manual for accurate and safe adjustment of the pressure and flow compensator on the Danfoss M Series Piston Pump.
Add New Comment