User Manual Q&AAnswer
Jan 28, 2025 - 11:12 PM
To wire the ITC 690471 Compel Linear Light to the power unit, please follow the steps below:
1. Disconnect power: Before starting the installation, make sure to disconnect the power source to avoid any electrical hazards.
2. Determine installation location: Decide where you want to install the light and mark the clip locations accordingly.
3. Mounting clips: Drill pilot holes at the marked locations and xxxx in the provided mounting clips using the provided screws. Ensure the clips are securely fastened.
4. Wiring: Refer to the wiring diagram provided in the installation guide. Connect the wires from the light to the power unit according to the diagram. Make sure to match the positive (+) and negative (-) terminals correctly.
5. Snap light into mounting clips: Once the wiring is complete, carefully snap the light into the mounted clips. Ensure that the light is securely attached.
It is important to note that this product operates at a maximum voltage of 12V DC ± 20%. The light is dimmable from 10% to 100% and is designed for interior use only. The operating temperature range is -20° to 50°C.
For any warranty information or further assistance, you can visit the manufacturer's website at www.itc-us.com/warranty-return-policy or contact them directly at the provided phone number: 616.396.1355.
Add New Comment