User Manual Q&AAnswer
Jan 28, 2025 - 10:38 PM
Installation of the ENDORFY EY4A004 Fluctus 140 PWM ARGB PC Fan is a relatively straightforward process. Here are the steps to follow:
1. Ensure that your PC is powered off and unplugged from the electrical outlet before proceeding with the installation.
2. Identify the location where you want to install the fan. It is typically mounted on the front, rear, or top of the PC case.
3. Remove the side panel of your PC case to gain access to the internal components.
4. Locate an available fan mounting spot in your PC case. The mounting spots are usually indicated by xxxx holes or brackets.
5. Align the xxxx holes on the fan with the corresponding holes on the mounting spot.
6. Use the provided screws to secure the fan in place. Ensure that the fan is firmly attached but be careful not to overtighten the screws.
7. Connect the fan's power cable to the appropriate fan header on your motherboard. The fan header is usually labeled "SYS_FAN" or "CHA_FAN" and may be located near the mounting spot.
8. If your fan has ARGB (Addressable RGB) lighting, connect the ARGB cable to the appropriate ARGB header on your motherboard or ARGB controller. Refer to your motherboard's manual for the specific header location and connection instructions.
9. Once the fan is securely installed and the cables are connected, close the PC case and reattach the side panel.
10. Power on your PC and check if the fan is spinning and the lighting is functioning properly.
Please note that these instructions are a general guide and may vary depending on your specific PC case and motherboard. Always refer to the product manual for detailed instructions and consult your PC manufacturer's documentation if needed.
Add New Comment