User Manual Q&AAnswer
Jan 28, 2025 - 10:07 PM
To attach the ELECOM MSC-TB-APSG-W Glass Screen Protector with Guiding Frame to your device, please follow these steps:
1. Before attaching the screen protector, make sure to place it on the LCD screen and ensure that it is aligned properly.
2. Turn off your device and use the included cleaning cloth to wipe off any dirt on the screen.
3. Use the attached dust remover sticker to clean the screen and remove any dust particles.
4. Attach the guide frame to your device according to the orientation of the words on the guide frame.
5. Remove the protective sheet from the screen protector and attach it to the screen. The side without the protective sheet should be attached to the screen.
6. Check the position of the camera on your device and align the film with the guide frame.
7. Affix the center of the screen protector and then slowly apply it in such a way that the bubbles are forced out from the center to the edge. Remove the guide frame after applying the film and before use.
To remove air bubbles, lightly press the bubbles to the edge of the protector using the spatula or your finger. Small air bubbles will become smaller and less noticeable over time. Avoid using your fingernails to remove the air bubbles as it may scratch the film.
To remove the screen protector, slide the protection sheet between the screen protector and the device. Slowly lift the screen protector off, taking care not to bend it too much.
Please note that this product is made of glass, so if it breaks, discontinue use and remove the screen protector with care. Also, be aware that this product does not completely prevent scratches and dirt on the LCD screen.
For more information and precautions, please refer to the user manual provided with the product.
Add New Comment