How do I install the Martec Aspire Lux 3in1 Heater Light and Exhaust? (martec Aspire Lux 3in1 Heater Exhaust Instruction Manual)

Answer

manuals.plus

Jan 28, 2025 - 10:01 PM


To install the Martec Aspire Lux 3in1 Heater Light and Exhaust, please follow these steps:

1. Use the provided cutout template to mark the hole cutting size on the ceiling. Ensure that the area behind the intended location is clear of cables, pipes, and joists.

2. Prise up the edge of the fascia and remove it. Remove the cover of the terminal and connect the wires according to the provided diagram. Connect the ducting to the unit if required.

3. Insert the unit into the ceiling cavity, ensuring that the clips are resting against the body of the unit. Tighten the screws to secure the unit.

4. Take out the glass and insert one side into the slot, then push the opposite side in. When the glass is in a horizontal position, it will be seized by the bottom slot.

5. Push the edge of the fascia towards the housing and let the clips on the fascia fix onto the housing.

6. To access the tricolour switch, remove the front fascia to reveal the screws securing the LED light. Undo the screws and pull out the LED light. The switch will be located on the back of the LED light.

Please note that electrical wiring must only be done by a licensed electrician, and a "Certificate of Compliance" must be issued upon completion of the installation. It is important to follow all safety instructions and local building codes during the installation process. For more detailed instructions, refer to the Martec Aspire Lux 3in1 Heater Light and Exhaust Instruction Manual.