How do I install the MARTEC MBHV2000W Vapour 3-in-1 Fan Heater, Light and Exhaust in my bathroom? (martec MBHV2000W Fan Heater Exhaust Installation Guide)

Answer

manuals.plus

Jan 28, 2025 - 08:54 PM

To install the MARTEC MBHV2000W Vapour 3-in-1 Fan Heater, Light and Exhaust in your bathroom, please follow the steps below:

1. Read the installation instructions carefully and ensure that you have all the necessary tools and materials.

2. Locate the desired location for the unit in accordance with AS/NZS 3000 and local building codes relating to damp situations. Ensure that no part of the unit is located directly above any part of a bath or shower recess or enclosure.

3. Use the provided cutout template to mark out the hole cutting size on the ceiling. Before cutting, ensure that the area behind the intended location is clear of cables, pipes, and joists.

4. Prise up the edge of the fascia and remove the fascia to access the internal components. Disconnect the LED plug from the heater unit and remove the cover of the terminal. Connect the wires according to the provided diagram. If required, connect the ducting to the unit.

5. Insert the unit into the ceiling cavity, ensuring that the clips are resting against the body of the unit. Tighten the screws to secure the unit in place.

6. Select the desired color for the LED light using the tricolor switch at the back of the LED light panel. Connect the LED plug to the fascia and push the edge of the fascia towards the housing until the clips on the fascia fix onto the housing.

7. Connect the wiring to the five-gang switch according to the provided electrical diagram. Remove the terminal cover on the heater unit and wire according to the label adjacent to the terminal block. Ensure all cables are securely connected and refit the terminal cover.

8. Clean the fascia and lighting panel with a soft, moist cloth.

9. Turn on the power and check the switch operation.

Please note that electrical wiring must only be done by a licensed electrician, and a "Certificate of Compliance" must be issued upon completion of the installation. It is important to follow all safety instructions and guidelines provided in the manual to ensure proper installation and usage of the product.